GoPinball.com
http://gopinball.com/forum/

No DMD on Zedonius "Attack from Mars"
http://gopinball.com/forum/viewtopic.php?f=88&t=5431
Page 1 of 1

Author:  GeorgeH [ Tue May 26, 2015 9:07 am ]
Post subject:  No DMD on Zedonius "Attack from Mars"

I downloaded the Zedonius version of "Attack from Mars" from PinSimDB. The table played correctly although there is no DMD when I play it. Is there a way to display the DMD?

Author:  Gimli [ Tue May 26, 2015 10:30 am ]
Post subject:  Re: No DMD on Zedonius "Attack from Mars"

are you using a cab or desktop?
have you tried togglehud key?
Do you want a hud or backglass DMD?
you can switch between the two in table editor . lets say in translite view in table editor
you have a backglass DMD named DispDMD1. If you want a hud dmd instead, then delete
the backglass DMD and create a new hud DMD and use the same name. DispDMD1

sometimes in translite view you'll see a DMD dragged off to the side, in this case, just
drag it back onto translite. BTW The table hud DMD is placed over the translite view and not in table view as you would expect.

Author:  GeorgeH [ Thu May 28, 2015 1:50 pm ]
Post subject:  Re: No DMD on Zedonius "Attack from Mars"

I have a desktop installation with a single monitor. The togglehud key doesn't turn on the DMD. I don't use the backglass and like the DMD to appear in the upper left hand corner of the display.

Author:  Gimli [ Thu May 28, 2015 2:37 pm ]
Post subject:  Re: No DMD on Zedonius "Attack from Mars"

right.....so change the backglass dmd
to a hud dmd like I instucted above

and place your new hud dmd in the top left
of the translite

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/