GoPinball.com
http://gopinball.com/forum/

  how to allow a collision with a 3d model ?
http://gopinball.com/forum/viewtopic.php?f=84&t=9901
Page 1 of 1

Author:  backup [ Thu Apr 18, 2019 11:05 am ]
Post subject:    how to allow a collision with a 3d model ?

I assigned a 3d model (shield) as a target.
but the ball goes through the shield.
  how to allow a collision ?

Author:  HappyCab [ Thu Apr 18, 2019 11:20 am ]
Post subject:  Re:   how to allow a collision with a 3d model ?

Create a wall from a surface or guide and turn it invisible

Author:  backup [ Thu Apr 18, 2019 12:44 pm ]
Post subject:  Re:   how to allow a collision with a 3d model ?

ok , but but the shield must rise, after being touched.....

Author:  HappyCab [ Thu Apr 18, 2019 4:28 pm ]
Post subject:  Re:   how to allow a collision with a 3d model ?

look at any of my table I have plenty of these..
you trigger the collision on your hidden wall when the shield is up and cancel it via script when it is down.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/